P0325 knock sensor Fix?

[Xfinalresort]

How about it guys, is there any thing i can do to get rid of a P0325 code on a b17 engine with a b16 ecu? Its the last thing i need to do to make my car pass inspection.

[16 BLOCKS]

Wire up the knock sensor and u should be good

[ManTyme]

you need to bypass the knock sensor since the ECU is looking for it and the B17 doesnt have one

[Xfinalresort]

Is there a write up somewhere to doing this?

[2point1]

LSVTEC people do this


Using a 10.9 mm drill bit, opened up the hole on the bracket and the block. Then carefully tap the hole with a 12 mm x 1.25 thread pitch tap. Be sure to clean up the shavings and then screw the knock sensor. This will keep your ECU from throwing any codes.

[Xfinalresort]

A+ write up mate! Thank you!

[Xfinalresort]

Sorry to bring up an old thread but i need help on this subject again. So i did every thing above but, i am completely spacing out on the wireing. is it possable to just run my own wire to the ecu connector (C3) or do i need to find it in my wiring harness?

[CTgoldhatch]

you can run it right to the ECU

[Xfinalresort]

Okay sounds good, I'm open to all segestions but I'll play with it some more tomorrow. Suppose to be nice outside.

[Bxdragon]

have a chipped ecu bypass it. I just was wondering

[Xfinalresort]

Yeah I have a chipped p30or 28 (mind blank) but I need to clean the cel in order to pass Mass inspection. I also am throwing a code for both o2 sensors the post car isent even hooked up so that obvious. The first one might be because of the second one

[Xfinalresort]

I wired it up to c3 off of the wireing harness and it's still triping a code after 5-10 mins of driving. Only other thing that I can think of is that it has a bad connector plug... I need to figure this crap out...

[ekrican77]

get a p28 they dont ask for a knock sensor

[ekrican77]

so its a b17 gsr in what kind of car??

[ekwemo]

no bypass it go to ff-quad.com come trust and youe alset