Announcement

Collapse
No announcement yet.

Failed CT emissions AGAIN

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Failed CT emissions AGAIN

    This is driving me crazy.

    I have no idea where to even begin on how to solve this.
    My first Attempt to get emissions done the test was aborted due to the Ecu not communicating with the Obd2 port. After I set readiness on KPro I went to auto zone and with their obd2 I checked to make sure everything was fine. The reader stated that the required monitors for emissions were ready and that no engine codes were present.

    That was a saturday. I wasn't going to make it to a test station so I just parked the car for the week. This afternoon I go to emissions and the car failed. I'm looking at the report All readiness code and status are okay. However I failed because I'm throwing a p0134 code. Mind you my check engine light is not even ON. It's stating that the there is no o2 sensor activity.

    Any ideas? I got to pass emissions to be able To renew my regitration. The car is gonna sit anyway till spring but I just want to get this thing resolved. Any ideas guys?

    Car has a k24 swap with KPro.

  • #2
    Go into kpro and disable your secondary o2 sensor
    (860) and beyond
    #DavesTuning 8608050968

    Comment


    • #3
      After disabling the second o2 basically clear all DTC and set readiness again?

      How can the second sensor be the cause?

      Comment


      • #4
        up

        Comment


        • #5
          sounds like what happened to my pops and his truck we fix all the probems and no check engine light but it still failed because the truck was just sitting for so long the next day we brought it back he had me beat the living piss out of it so all the carbon and shit settled in the motor came out drove it right to emission 20 mins later and passed i dont know just throwing some thought out there good luck!
          knuckk.

          Comment


          • #6
            This might help you out, any car 2000 and older is allowed 2 drive cycle monitors inconclusive to pass and anything newer than 2000 is allowed one. So if you clear the code,(then using an actron advanced auto scanner) go to drive cycle monitors and drive the car until you can kick a few monitors off n run it right thru emission when those monitors go off before the light comes back on. This is assuming its not a hard code that comes right back on. Hope it helps ya out

            Comment


            • #7
              is there anyway other way we can pass emissions... i have a car that needs to go but there is no way im putting the car back to stock... any ideas?

              Comment


              • #8
                take the car to the emissions place in bpt next to kfc by the dmv
                theyll pass anybody, they passed my boys k20 with a 3inch and no cat

                Comment


                • #9
                  I probably should have clarified....

                  I have a 2005 EP3.

                  Comment


                  • #10
                    Originally posted by honda 97 View Post
                    take the car to the emissions place in bpt next to kfc by the dmv
                    theyll pass anybody, they passed my boys k20 with a 3inch and no cat
                    Doubt it they failed my moms car mad times n come to find out the bulb for the check engine light was out
                    FOUR DOORS FOR MORE WHORES

                    Comment


                    • #11
                      how many times can a vehicle fail emissions?
                      How do I go about trying to get an extension.

                      I'm going to try to replace the primary this saturday. I'll clear all DTC, and set readiness.

                      Comment


                      • #12
                        Originally posted by Kerby View Post
                        how many times can a vehicle fail emissions?
                        How do I go about trying to get an extension.

                        I'm going to try to replace the primary this saturday. I'll clear all DTC, and set readiness.
                        Make sure the bulb itself isn't blown because u will keep goin back n if will give u a headache n the only other thing u can do is u have to get emissions done atleast 3 times then provide proof that Werk was done by a mechanic signed by the mechanic and they'll pass h n let u renew regi
                        FOUR DOORS FOR MORE WHORES

                        Comment


                        • #13
                          Originally posted by bptboy View Post
                          Doubt it they failed my moms car mad times n come to find out the bulb for the check engine light was out
                          x2 they failed my grandfathers tahoe 2 years in a row for the same thing, mind it they charged him over $600 a year prior and the same stuff popped back up again.....we brought it to another place and it past no problem
                          20 Years Young Currently Driving a Carbon Grey Pearl 6 speed TSX

                          Comment


                          • #14
                            Someone told me they don't cancel registration anymore they just want the cars to be in compliance and go fail or no fail idk how it is anymore they change the rules so much.. Well i hope you get this resolved g/l
                            860 member #18
                            puerto roc #1
                            Cosa nostra
                            ASAPRadio.net
                            "Hatred is the coward's revenge for being intimidated.”

                            " The man who knows "how" will always have a
                            job.....the man who knows "why" will always be his boss"

                            Comment


                            • #15
                              well i'll find out next week when i go to register my new car cuz i doubt imma pass with a straight pipe lol
                              20 Years Young Currently Driving a Carbon Grey Pearl 6 speed TSX

                              Comment

                              Working...
                              X