lc-1 wideband install help

[eg-spoon]

hi i know some of you have install a wideband before, what i'm trying to do is remove my stock o2 and replace it permanantly with the wideband o2 and , and read my af with the innovative db gauge, i have all my wires install minus the analog1 and 2, my question is wich wire should i connect to my gauge and witch to my ecu ,

[panch]

you can use either or.. just make sure the channel you hook to the ecu is calibrated as narrow band. unless you are trying to tune with it..

[astroboy]

I beleive the brown one is narrow band...it says it in the little pamphlet that comes with the lc-1. Don't forget to let it self calibrate before you put it in!

[YatesTunes]

Just tape up the yellow wire with some electrical tape and tap the brown wire into your harness. The system self calibrates on the first start up. Then connect the LC-1 to a laptop and calibrate it for a narrowband sensor with a range of 0-3.8 volts as the stock ecu doesn't operate on a 5 volt signal.