lower ball joint help

[blanco~db7]

My ball joint popped yesterday. Now the joint was stuck in the lca. I managed to pop it out of the lca. But the top half is stuck in the knuckle. I tried hammering it out & nth. Also broke my c clamp. Any ideas on how to get it out without a press. Any ideas will be greatly appreciated.
My axle also broke at the boot & i can't get it outta the shaft. Tried prying it. Hammering the pry bar & nth
Really need to fix today I work at 5am tomorrow

What I have of the ball joint removed

[elcabron]

heat it up and hammer it out

[hondagsr]

Use a small sledge hammer

[blanco~db7]

Tried heating it but don't think my torch gets hot enough

[allmotork24]

There's a clip that holds the ball joint in the knuckle you have to remove it first before hammering it out

[blanco~db7]

There's a clip that holds the ball joint in the knuckle you have to remove it first before hammering it out

I ripped the clip off last night lol

[honda4civic]

thats y u fix shit before something like this happen gl bro on the fixing

[blanco~db7]

thats y u fix shit before something like this happen gl bro on the fixing

Wasn't aware that it needed to be replaced. I just did it last may & yesterday it decided to go again & take the axle with it lol

[WAngel]

Go to any autozone or advanced or pep boys they rent out a ball joint press...it looks like a big ass C clamp...get a socket that fits tha end and jus press it out

[blanco~db7]

No money. To go rent it I'm flat broke til payday.
That's why I'm glad I have both under warranty
That's why I'm Trying to find a way around using a press