brake failure help....

[YOMORACING JOSE]

for the last couple weeks my brake pedal felt really soft.... i thought it might have been my front brakes... so i upgraded to the whole si spindles... the brake pedal stil felt soft after bleeding the brakes so now im thinking its my rear shoes... but just the other day i was speeding and some dick head cut me off and i slammed on my pedal, i felt something squirt out from my firewall.. and now after couple miles my car is in need of brake fluid.... does anyone kno wat this can be??? any answers will be gladly appreciated thank yu...

[hondagsr]

Master cylinder or a leaky brake line

[turbobub2.0]

my partner just went through it at the shop with an accord and the answer is THE MASTER!

[SeanJDMJohn]

Could be the master or booster* If u said u felt the squirt lmao no pun intended

[d&gauto]

Could be leaking inside the brake booster from the master cylinder

[SeanJDMJohn]

Could be leaking inside the brake booster from the master cylinder

That what I ment to say master gasket is bad in-between the master nd booster or the whole shit could just be bad all together if u felt a squirt on ur leg or something DO U SEE ANY FLUID ON UR CARPET OR NE THING

[Ludin203]

like everyone else said, your master cylinder is leaking. its located right above your pedals on the other side of the firewall and thats why u felt something leak. replace it and bleed your system and you should be good to go.

[Ludin203]

That what I ment to say master gasket is bad in-between the master nd booster or the whole shit could just be bad all together if u felt a squirt on ur leg or something DO U SEE ANY FLUID ON UR CARPET OR NE THING

i would check the gasket or w.e like this guy said too, maybe both r bad....

[YOMORACING JOSE]

thanks for everyone help... ill check it out tomorrow and keep in touch... and by gasket wat do yu guys mean???

[YOMORACING JOSE]

and the leaking is going on the outside of the car on the driver side... no leak inside

[SeanJDMJohn]

Okay I kno this cause I did my booster 180 to tuck the vacume hose when u take the two nuts off to take the master cylinder off the booster there is a rubber black gromet with a whole in the middle for the push rod ill get pix for u now

[YOMORACING JOSE]

Okay I kno this cause I did my booster 180 to tuck the vacume hose when u take the two nuts off to take the master cylinder off the booster there is a rubber black gromet with a whole in the middle for the push rod ill get pix for u now

thanks broo.. this will be very helpful. pic will also help alot

[SeanJDMJohn]

HERE U GO THIS IS A PIC OF THE BLACK RUBBER GASKET/GROMMET I'D SAY CLEAN IT UP
TWO THIS IS A PIC OF THE MASTER U SEE THE CROME PUSH ROD THIS IS WHERE THE GASKET SHOULD BE LOCATED OR IT PROBLY WILL STILL BE IN THE BOOSTER HOLE TAKE IT OUT/ OFF BUT IF U DO ALL THAT I WOULD JUST GET A NEW MASTER UR WELCOME JUST TRYIN TO HELP WIT PIX

[ej1 sleeper]

could be ur master cylinder brotha..

[ej1 sleeper]

or a brake line near ur caliper might have a slit in it...(i had that problem before)