Chagy87 LS-V 2nd/3rd Gear Pull

[lsdb1]

3/4 throttle pull from 2nd to 3rd on a B16 tranny sprinning most of 2nd on shitty 14 inch tires. 172whp & 129lbs tq

[91EscortGT]

thats goooood shit my nigga!

[chagy87]

oh shittt my slow ass car next time well put full throttle when i get my rims back these steelies aint doing it

[lsdb1]

oh shittt my slow ass car next time well put full throttle when i get my rims back these steelies aint doing it

Word, they're almost done so no worries

[CTgoldhatch]

so stock bottom end?

[lsdb1]

so stock bottom end?

Im putting you out there Antonio

B18 block
CTR Pistons
LS Rods
Forged LS Crank
ACL Bearings
ITR oil and water pump along with CTR Crank Pulley

[CTgoldhatch]

so the motor will be junk soon then cuz i take it you never changed the stock rod bolts to arps? reving it like that with stock LS rod bolt it will blow up there were not built to handle them RRRRR's

[lsdb1]

so the motor will be junk soon then cuz i take it you never changed the stock rod bolts to arps? reving it like that with stock LS rod bolt it will blow up there were not built to handle them RRRRR's

Not sure about the rod bolts to be honest

[CTgoldhatch]

if they are stock ones i would not be revvin it like that bearings will fail sooner.

[chagy87]

here the bottom end

ITR piston not CTR
LS Rods
Forged Crank
ACl Be..
ARP Hardware
ITR/GSR oil pump Water pump
CTR crank Pulley which i might be changing soon cause i dont wanna ************ up the Oil pump

[CTgoldhatch]

CTR pulley sould be only used on high speed balanced motors.

[lsdb1]

here the bottom end

ITR piston not CTR
LS Rods
Forged Crank
ACl Be..
ARP Hardware
ITR/GSR oil pump Water pump
CTR crank Pulley which i might be changing soon cause i dont wanna ************ up the Oil pump

I thought you said they were CTR's

[chagy87]

no nigga ITR i neva said CTR i told you i wish i would of got some 82.5 mm CTR since they hhave a lil more compression

[CTgoldhatch]

I thought you said they were CTR's

CTR=1.6
ITR=1.8
he needs itr for a LS

[chagy87]

well the point is its not bad for an almost all OEM built motor

my next one im going all out
gonna take about a year to finish though