96 accord crank no start batt. light flashing

[lowcruzinteg4]

so i replaced a cylinder head on a 96 accord due to bent valves the car ran when i it had bent valves but ran rough so i replaced the head. now i try and start it im getting a crank no start and ever so often itll skip like it wants to start i think all my grounds are good i charged the batt. over night and everything timings good.the only thing is the spark plug wires where it contacts the spark plug is caked with oil....if anyone could help out i gotta get this car on the road thanks ctv

[lowcruzinteg4]

bump somebody must have thoughts just tryin to bounce ideas around

[wildlatino89]

Check your crank sensor and you top cam sensor check to see if theres any spark too!!

[lowcruzinteg4]

Check your crank sensor and you top cam sensor check to see if theres any spark too!!

you top cam sensor? and thanks got spark i gotta check timing and recheck grounds..

[wildlatino89]

you top cam sensor? and thanks got spark i gotta check timing and recheck grounds..

Yes theres two sensor on the side of the timing and the top sensor is a cam position sensor

[lowcruzinteg4]

o yea both are good....
the car ran before i changed the heads the just ran poor because of bent valves...

[hondaguy]

I would start by cleaning that oil that is caked in there. It happened to my old accord a long time ago. The gaskets got old and the oil got through into there and the car wouldn't start

[lowcruzinteg4]

I would start by cleaning that oil that is caked in there. It happened to my old accord a long time ago. The gaskets got old and the oil got through into there and the car wouldn't start

tried with break clean...think im going to get new wires there only 40$ At the zone...

[lowcruzinteg4]

did ur batt light flash^^?

[lowcruzinteg4]

ttt

[lowcruzinteg4]

ttt

[lowcruzinteg4]

ttt anyone

[lowcruzinteg4]

ttt