ITB question??

[LS/Vtec]

^How do you know the enigne is stock? and not built?

[b16eg684]

well its clear hes going with obx itbs since they are going on a stock motor. without high compression itbs are rather useless. turbohatch900 clearly doesnt know much dont pick on him. if you dont have ATLEAST STAGE 1 CAMS! and 11:5:1 or over compression DO NOT BOTHER its a waste of money and if you dont have the cash for twm dont bother. h22 built with itbs will skoot pretty good if you do everything right but from the sound of it you are peicing this together last minute. id also suggest a yosolo tune on this set up...
you wanted it, you got it

x2....and you better be running HONDATA or better!!! and at least 550 injectors to feed them bad boys. and you are going to need a GOOD header hytec, rmf, etc

[LS/Vtec]

How do you figure? Itb's aren't worthless on any motor unless the motor is stock. If you aren't building the engine then don't go with itb's just stick to a decent manifold setup.

But here ya go...

-Itb's
-Coolant
-Throttle Cable
-Intake Mani Gasket
-Injectors
-Fuel Lines
-Vaccum Block
-Vaccum Lines
-Tune, Tune, Tune

It all depense on what kind of itb's you go with on which you need.

Just realized i typed just intake lol

[b16eg684]

ITBs on a built H with good other supporting mods make EXTREMELY good power with very nice power and torque throughout the curve and entire powerband. dyno proven

[Bsickteen]

Drivability will become very poor with ITB. ITB's work best on high reving motors and wide open throttle, not part throttle. For the street ITB's become a real pain in the ass. But they look cool as hell!

[LS/Vtec]

my shit sounded like a v8 lol. cuz it was cammed out n idled like it. I loved it lol. And the throttle response was fuckin sick.

[Bsickteen]

my shit sounded like a v8 lol. cuz it was cammed out n idled like it. I loved it lol. And the throttle response was fuckin sick.

The throttle resonse is either on or off, theres no in between with ITB's.

[latinman07]

thanks for the info every one

[LS/Vtec]

http://vids.myspace.com/index.cfm?fuseaction=vids.individual&videoid=45404266

[latinman07]

it look nice

[accord9483]

WHY IS IT A WASTE...? I HAVE A FULLY BUILT BOTTOM END 97 H22A4 AND I NEED THE HEAD DONE ANY SUGGESTIONS... ON PARTS I NEED CAM SHAFTS SPINGS, RETAINERS, VALVLES, ETC...

[SKUNK 2.2 COUPE]

Listen if u have the itb ill buy them off u or ill trade u my skunk 2 manifold an work something out pm me if so

[SahmeeBuilt]

bump for the people actually providing info..