b20v in ek bogging

[JDMEGVTEC]

i just read something about bypassing the ckf to make it runproperly because im running a jdm b20b block and im using my stock single cam obd2b engine harness so it will make it run like shit but im also using a step down harness and an obd1 chipped p28 so im confused if that will disable the ckf in the first place

The CKF is in the dizzy for obd1 cars and obd2 cars have it on the oil pump JDM motors don't have that, by bypassing it tricks the Ecu into thinking its being read it takes like 5 minutes to do I would try it out also there are several DIY here's one that works http://www.ff-squad.com/technet/ckftrick.htm good luck

[anthonyb5s4]

^^^thanks

[JDMEGVTEC]

If that doesn't workout get an obd1 dohc Vtec dizzy and jumper for the dizzy worst case

[anthonyb5s4]

well i did the ckf bypass and the iac map and tps are all plugged in properly so far no luck

[H22SteakSauce]

Did u do what I said?

[anthonyb5s4]

Did u do what I said?

not yet im going to do it tomorrow

[anthonyb5s4]

The CKF is in the dizzy for obd1 cars and obd2 cars have it on the oil pump JDM motors don't have that, by bypassing it tricks the Ecu into thinking its being read it takes like 5 minutes to do I would try it out also there are several DIY here's one that works http://www.ff-squad.com/technet/ckftrick.htm good luck

im a lil confused when u cut the 2 wires do you cut the end close to the ecu or close to the engine?

[anthonyb5s4]

ttt