b20v in ek bogging

[anthonyb5s4]

is some sensor guaranteed. i cant remember which one they are but they're are 2 sensors on the intake manni and if they are swapped it can run like shit. theyre the same plug so its easy to plug it into the wrong one.

imma check that and no cel im on a chipped p28

[V8-KILLER]

get a real tune

[anthonyb5s4]

get a real tune

that has nothing to do with it right now if that was the case it would hav ran like shit in the EG too

[EJ8-Type R]

I remember this happen to my swap before and i had a bad iacv try changing that if anything

[anthonyb5s4]

I remember this happen to my swap before and i had a bad iacv try changing that if anything

imma try that cuz it does idle up and down, also when i go to start it, it wont turn on if its cold unless i giv it gas

[EJ8-Type R]

It's deff that then my car did the same thing. It will drive fine but like you said once you get on the gas a bogs out. Good luck

[anthonyb5s4]

thanks imma replace it and see what happens thanks

[anthonyb5s4]

oh yeah i forgot to mention when i had my ecu chipped i had it progtammed to pop vtec at 4500 rpms but now it pops at 5000

[Bang Bros]

Had the same problem with my single cam and belive it or not I did a head gasket and it never bogged again and I thought it had something to do with the dizzy or fuel

[anthonyb5s4]

Had the same problem with my single cam and belive it or not I did a head gasket and it never bogged again and I thought it had something to do with the dizzy or fuel

couldnt be that tho cause i didnt hav this problem until i put it in a different shell

[anthonyb5s4]

i just read something about bypassing the ckf to make it runproperly because im running a jdm b20b block and im using my stock single cam obd2b engine harness so it will make it run like shit but im also using a step down harness and an obd1 chipped p28 so im confused if that will disable the ckf in the first place

[honda 97]

imma try that cuz it does idle up and down, also when i go to start it, it wont turn on if its cold unless i giv it gas

seems like maybe you have the sensors plugged in maybe wrong, could maybe mixed up the iac and the iat sensors plugs maybe

[anthonyb5s4]

seems like maybe you have the sensors plugged in maybe wrong, could maybe mixed up the iac and the iat sensors plugs maybe

i just got a diagram from a 98 ex engine harness i believe the wore colors are the same so im gonna go thru the wires and stepdown harness and see what happens, also wheneer u get the chance i need the ecu reprogrammed

[H22SteakSauce]

Check the coolant temp sensor under the dizzy. There's two plugs that plug into it I mixed those up once and had to give it gas to start lol carbureted ass shit

[anthonyb5s4]

Check the coolant temp sensor under the dizzy. There's two plugs that plug into it I mixed those up once and had to give it gas to start lol carbureted ass shit

^^that actually mite be the issue rite there i never even bothered to check that