GSR Clutch problems

[Christian_Chand]

RECENTLY replaced my slave cylander/***
think my clutch may be going out. tonight it was acting funny. Sometimes rough shifting, usually into third. Then i was getting ready for the light to change, clutch in and in first gear (sometimes difficult to put into), and the car started to like shakes rapidly like it was stalling then it grabs the gear and works. then the shifting is very rough and when in gear and accellerating there is a quiet but high whistle noise as i accelerate. its hard to put it in third, it takes a hard push....and keep in mind this happened when it was getting colder out here last night and today all day it was freezing

not tryna do a clutch right now lol

[JDMTypeR]

I kinda had the same problem the other day. I couldnt shift into third. It didnt wanna qo in.

[game2o3]

did you bleed it right ??

[vtec_kid]

make sure u have some oil in the tranny. or it could be throw out bearing going bad or pressuer plate

[LS/Vtec]

Id replace the master cylinder. And go from there. I would think if the pressure plate was fucked up it would do it all the time. But then again you never know. Its a Honda.

[Christian_Chand]

i did bleed the clutch when i did the slave cylander like a month ago

[egkid_93]

I had basically the same prob..changed pressure plate n it stopped along with master cylinder (one tht connects to your clutch pedal) n slave cylinder...