Announcement

Collapse
No announcement yet.

Someone HELP

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Someone HELP

    Going to run Ctr pistons what kinda rigs should I use ?
    I STILL ROCK OEM WHEELS AND IM PROUD!

  • #2
    Oem
    WILSON BUILT

    Comment


    • #3
      oem like P-CRIDER
      I hate thieves wit a pasion, stop being some bums and get a job....

      Comment


      • #4
        said
        I hate thieves wit a pasion, stop being some bums and get a job....

        Comment


        • #5
          Oem Ctr or b16 ??
          I STILL ROCK OEM WHEELS AND IM PROUD!

          Comment


          • #6
            if your talking about rings b16 gsr or type r rings will fit because they are all 81mm.
            97 Boosted Hatch my toy
            04 Acura Tl 6 Speed daily driver.

            Comment


            • #7
              Yea but I put stock oem b16 rings and it's casing blow buy like a mother fucker
              I STILL ROCK OEM WHEELS AND IM PROUD!

              Comment


              • #8
                Originally posted by MYeg'sALLMOTOR View Post
                Yea but I put stock oem b16 rings and it's casing blow buy like a mother fucker
                were they new and did you gap them and put them on correctly.
                97 Boosted Hatch my toy
                04 Acura Tl 6 Speed daily driver.

                Comment


                • #9
                  Make sure your piston ring end gaps are correct. If you have the stock 81mm bore your top compression ring should be gapped to 0.019" and your second compression ring should be gapped to 0.023" as for the oil rings, just check to make sure they're not gapped smaller than 0.015".
                  Hidin' out

                  Comment


                  • #10
                    were the cylinders honed prior to putting new rings in??
                    !!!!!ThE GoOd DiE YoUnG!!!!!
                    R.I.P NHSWAPS 13203

                    Comment


                    • #11
                      If you honed the cylinders you have to account for the extra material taken off of the cylinder wall. Get a micrometer and measure the cylinder bore. Got to your local machine shop and give them the measurements of the piston and the cylinder wall and they will set you up with the best set of pistons. Do not gap them too much becuase you WILL get serious blow by.
                      RIP NHSWAPS13203

                      Comment


                      • #12
                        Is it a B16A block or what?
                        RIP NHSWAPS13203

                        Comment


                        • #13
                          Ma I dident hone them but the block was runing bfor I changed every thing
                          I STILL ROCK OEM WHEELS AND IM PROUD!

                          Comment


                          • #14
                            And yea it's a full jdm b 16
                            I STILL ROCK OEM WHEELS AND IM PROUD!

                            Comment


                            • #15
                              PM'd
                              RIP NHSWAPS13203

                              Comment

                              Working...
                              X