Someone HELP

[MYeg'sALLMOTOR]

Going to run Ctr pistons what kinda rigs should I use ?

[P-CRIDER]

Oem

[Purple_Ej1]

oem like P-CRIDER

[Purple_Ej1]

said

[MYeg'sALLMOTOR]

Oem Ctr or b16 ??

[realjdm]

if your talking about rings b16 gsr or type r rings will fit because they are all 81mm.

[MYeg'sALLMOTOR]

Yea but I put stock oem b16 rings and it's casing blow buy like a mother fucker

[realjdm]

Yea but I put stock oem b16 rings and it's casing blow buy like a mother fucker

were they new and did you gap them and put them on correctly.

[Slicks]

Make sure your piston ring end gaps are correct. If you have the stock 81mm bore your top compression ring should be gapped to 0.019" and your second compression ring should be gapped to 0.023" as for the oil rings, just check to make sure they're not gapped smaller than 0.015".

[injen78]

were the cylinders honed prior to putting new rings in??

[B16eg6]

If you honed the cylinders you have to account for the extra material taken off of the cylinder wall. Get a micrometer and measure the cylinder bore. Got to your local machine shop and give them the measurements of the piston and the cylinder wall and they will set you up with the best set of pistons. Do not gap them too much becuase you WILL get serious blow by.

[B16eg6]

Is it a B16A block or what?

[MYeg'sALLMOTOR]

Ma I dident hone them but the block was runing bfor I changed every thing

[MYeg'sALLMOTOR]

And yea it's a full jdm b 16

[B16eg6]

PM'd