Announcement

Collapse
No announcement yet.

reving help asappppp

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    you using the sensor on the fire wall or the im? that may be the problem too

    Comment


    • #17
      Originally posted by NECTUNE203 View Post
      vac leak
      x2 check manifold to head bolts, and make sure the throttle is closing all the way and not stuck at a certain position.

      Comment


      • #18
        indeed
        My transmission's went 9's
        http://youtu.be/z2PHemIp_Tg

        Current: ap1 bb s2000,Mugen rep hardtop, RPF1's in SBC 17x8+45, 17x9+45, stopped by passwordjdm crossdrilled and slotted rotors and EBC redstuff pads, fujitsubo exhaust, Passwordjdm drycarbon snorkle, Passwordjdm drycarbon o.e.m airbox cover, Passwordjdm drycarbon cooling plate, tein hood dampners, K@N filter, Cusco 4 point cage with harness bar p/c candy blue, invidia test pipe, swift spec R springs on koni yellows, o.e.m style front lip, beaks limited edition hyper yellow tiebar.....more to come!

        91 crx hf project k-rx......top secret.

        91 crx si boosted sold, 92 hatch boosted sold, 95 coupe supercharged sold, 90 hatch ctr spray rip, 88 crx si fully restored rip, 89 crx si xsi swap rip.

        Comment


        • #19
          stratfoprd shelton area cant seem to fix this man lol

          Comment


          • #20
            holy wang ill far away
            My transmission's went 9's
            http://youtu.be/z2PHemIp_Tg

            Current: ap1 bb s2000,Mugen rep hardtop, RPF1's in SBC 17x8+45, 17x9+45, stopped by passwordjdm crossdrilled and slotted rotors and EBC redstuff pads, fujitsubo exhaust, Passwordjdm drycarbon snorkle, Passwordjdm drycarbon o.e.m airbox cover, Passwordjdm drycarbon cooling plate, tein hood dampners, K@N filter, Cusco 4 point cage with harness bar p/c candy blue, invidia test pipe, swift spec R springs on koni yellows, o.e.m style front lip, beaks limited edition hyper yellow tiebar.....more to come!

            91 crx hf project k-rx......top secret.

            91 crx si boosted sold, 92 hatch boosted sold, 95 coupe supercharged sold, 90 hatch ctr spray rip, 88 crx si fully restored rip, 89 crx si xsi swap rip.

            Comment


            • #21
              could it be something with the gas like injectors or fuel pump maybe your tb cable

              Comment


              • #22
                Fixed it some but still revving high and still reading bad sencors anyone have a throttle body with the sencors attached so I can see if it's anything else help please will give u parts haha I have stuff laying around valve covers and intake manifolds lol

                Comment


                • #23
                  ^^^ I got a MAP sensor. LMK
                  Cash given for OBD1 Virgin ECU's. Txt Me 860 394 8694

                  Comment


                  • #24
                    ttt someone wanna help me out with letting me barrow a throttle body with sencors so i can rule it out

                    Comment


                    • #25
                      Did u set your tps you can't just trow a new tps in without adjusting it.
                      S3-R
                      Stage3-Racing

                      Comment


                      • #26
                        i did tryto set it and calirate it but all i could get was a reading of 5v everytime idk why sucksss

                        Comment


                        • #27
                          If this anything lile what happened to me: Good luck! I would strongly encourage you to swap out the FITV with one from another car and see if that works!

                          With my car, out of the blue, the car reved by itself while idling. And as time went by, on start up (cold engine) it would rev to 3, 4 or 5k some times) until it got hot, and then idle went slowly down some, but higher than stock... After much tinkering on tps, IACV and other sensors, unbolted my FITV valve and found out it was broke (when i shook it, it rattled. It should not!). Bought a used one, cleaned it, tightened it, and voila! Idle reving really high fixed!! FITV FTMFW!

                          if that' aint it, good luck!!
                          Last edited by dj-bilbo; 11-20-2010, 09:33 PM.
                          92 EH2 - Red Daily beater

                          Comment


                          • #28
                            What's the fitv never heard of that

                            Comment


                            • #29
                              Originally posted by Lssplatter View Post
                              What's the fitv never heard of that
                              FITV=fast idle terhmo valve. It basically works with teh Iacv to regulate ur idle etc...

                              google is ur friend!
                              Acura Integra - *** How-To*** Clean Your FITV aka Fast Idle Thermo Valve - First things first, you have to determine if your FITV needs cleaning. Now if you?ve never done it before it probably does unless you bought a complete new one. Reasons why you should take it apart and cleaning it: -High idle before your car...


                              If this is ur issue, and urs is not broken, then it's a quick fix and easy!

                              good luck & keep us posted
                              92 EH2 - Red Daily beater

                              Comment


                              • #30
                                actrully that was going to be my next step to clean that part i wasent sure if i should of not once i get outta work ima try it thanks man

                                Comment

                                Working...
                                X