stupid idling help!!!

[ekrican77]

gotta be tha wrong wiring... check and make sure erething is properly wired... all tha plugs are plugged into tha rite place... and check to see if there is a hose from tha fuel reg to tha intake mani... is there a chek engine lite??

[jdmkain1706]

Yea i just read the codes one is the map sensor, another is the 02 sensor, and the other is electrical load detector

[ekrican77]

well google tha codes and where the sensors are located and fix it... its easy

[jdmkain1706]

Will do thanks bros

[djkiley]

goddamn idle problems. never ending on my ls. i just replaced the whole throttle body last week an still idling at 2k. did a smoke test on mine last night and have a huge leak between the tb and manifold. go figure. def do a smoke test if you havent yet

[ekrican77]

thats wat i do.. if i have a code i google it... check wat sensor it is and figure out wat i did wrong.. eitha tha wrong plug on tha sensor or tha sensor is just bad period, highly unlikely but happens... and sometimes it only displays some codes not ere code so it mite show 4 codes and than u fix all 4 codes and then different codes show up... just check tha codes figure out wat sensor is wat and make sure the plugs are plugged into tha rite sensor... GOOGLE IS YOUR BEST FRIEND LOL

[RHDDan]

is the cel on? has any gaskets been replaced, i'd check the bolts on the intake manifold, bolts on throttle body, bleed coolant, check timing on the distributor if advanced or retarded too much sometime it will mess with idle, what ecu are you running, is the motor completely stock?

[jdmkain1706]

The motor is completely stock and im using a p06 ecu gaskets has been replaced, distributor is at normal timing

[RHDDan]

have you tried any other ecu's and checked or tightened the bolts to the intake manifold.

[jdmkain1706]

I checked my boys chipped ls ecu and it ran fine after that so i guess i need a ecu

[PC-LEFTY]

change your MAP sensor mine was doing that when i changed it code 3 went off g/l

[jdmkain1706]

Thanks bros