LS smoking BAD!!!!

[toddmsc]

so i used seafoam in the motor and it smoked like it should but after a while got worse..i made sure i ran it all the way through but it kept smoking. Then i decided to do a different head, head gasket, and timing belt. i put new oil, antifreeze, and pcv. The plugs are beat but i dont think it would cause it to smoke this bad. the smoke has a light tint of blue and greatly increases after 4k rpm.....SOMEBODY HELP ME b4 this thing blows up :(

[Mr Layy]

try checking your compression....

[Spoon6]

sounds like ur rings are going

[88sprayincivic]

sounds like ur rings are going

I say the same thing.... happened to my old ef..you drive fine then past 4k smoke puffs out no one can see.....

[Spoon6]

lol same thing with my DA9 integra

[H23VTECLUDE]

sounds like ur rings are going

X2..........Kiss those babies good bye. lol.

[BIGBLACK]

lol same thing with my DA9 integra

yea bro ur piston rings
i loved my da lol:(

[88sprayinhatch]

yea bro ur piston rings
i loved my da lol:(

time to rip that bad boy out and for a fresh rebuild.. with some high comp pistons

[roe]

That's exactly what my b20 does I bet u have very uneven and or low compression..like they all said before ur rings are toast time for a rebuilt engine get a full gasket set pistons rings and bearings.

[toddmsc]

but the compression is fine and has all the balls in the world....i mean it still runs strong as hell, its not sluggish at all..it did 110 in a 1/4 when i got it and now it does 85 so it runs but not like it used to

[Spoon6]

belive me bro that engine is dying slowly time for rebuild

[toddmsc]

time to say fudge it and go get some JE high comp pistons some mint rods.....jack the thing up and rip it all apart from the bottom bc im not doin another head gasket them sh*ts are getting mad exxpensive and my job isnt keeping up with it lol

[H23VTECLUDE]

time to say fudge it and go get some JE high comp pistons some mint rods.....jack the thing up and rip it all apart from the bottom bc im not doin another head gasket them sh*ts are getting mad exxpensive and my job isnt keeping up with it lol

Good Luck Removing/Installing Pistons from the bottom?!?! Sorry, bro, not possible. LOL!

[LS/Vtec]

Good Luck Removing/Installing Pistons from the bottom?!?! Sorry, bro, not possible. LOL!

lol. x2. Def gotta pull the head off to pull the pistons/ rods out.

[jdmintegray0]

Lol I told u your rings gone..
that shit smokes at idle...