Ef hatch wheel hub.

[Alpinestar03]

My friend has a B16a swapped EF hatch. Hes got a bent front wheel hub and i know its not the stock d-hub ( i know nothing about b swaps really) and assume the hub is from a b series.

i have three questions.

1 Should i order integra hubs or 99-00 civic si hubs (there the same right?)

2 I can just take a hub puller (slide hammer) to take teh hub off right?

if so

3 would i need to get it pressed in the bearing?

thanks, all help is appreciated.

eric

[Sab]

Best Thing To Do Would Be To Get Integra Da Spindles From A Junk Yard.

[sikciv666]

Best Thing To Do Would Be To Get Integra Da Spindles From A Junk Yard.

x2...........

[Alpinestar03]

You mean the whole knuckle right? He just got a brand new bearing pressed in yester day so he wants to use that kunuckle. Hes not looking to buy used or aftermarket replacements. We are going to order through a local honda dealer..

So im assuming the DA hubs are what i need. Thanks guys!

but do i have to get it pressed in? or can i tap it in if i let it sit in the freezer for a while so it shrinks it?

thanks.

[ZeroTraction]

You mean the whole knuckle right? He just got a brand new bearing pressed in yester day so he wants to use that kunuckle. Hes not looking to buy used or aftermarket replacements. We are going to order through a local honda dealer..

So im assuming the DA hubs are what i need. Thanks guys!

but do i have to get it pressed in? or can i tap it in if i let it sit in the freezer for a while so it shrinks it?

thanks.

Si or DA or EX will work. DX will not the splines dont match.

[Alpinestar03]

Thank you, my friend got CRX SI knuckles, and the guy told him they'd work. The axles go into the splines good, but the axle is binding on the taperd part of the SI knuckle where the wheel bearing is. The knuckle we took off from his car was an integra knuckle with teggy brakes. Where the wheel bearing get pressed into, on the integra knuckle, is larger than where the bearing is pressed into SI hub.

Should i just pull the si hub and put it in the integra knuckle?

thanks

eric