rpm problem now

[artymillz]

ok so i bought a 93 gsr distributor and re wired it and the car runs now but i have no rpm gauge now.....or speedometer.....and its weak so must be the wrong distributor idk.....should i just take it off and put like a del sol b16 internals in....becuase idk if the 1.8 gsr internals are making the car run different then the 1.6 ones will

[Markie Mark]

im pretty sure the b16/GSR distributers have the same internals because there the same thing lol explain more and ill try to help

[ONE-CAM-EF]

all the internals are the same..my brother has the internals of a 1999 single non vtec in his 98 gsr dizzy..and it works just fine...i think is your wires that are mix up or something...

[artymillz]

yea i think u guys are right i pulled it off....my problem was i matched the colors and i hear your not supposed to so i just re-wired the whole thing heres the diagram i used....tomm ill have too install it and see if its right......

[Markie Mark]

let us kno if it works now

[artymillz]

i didnt go by that diagram up top because a few ppl said to match the colors and most of them did match but there was 2 white wires and u had to look for the bigger 1....well i ran those white wires both ways they can be....1 way wont start....and the other way will start but no gauges again...so somehwere in the same colored wires somethings wrong...and im not even sure if that diagram applies to me because when i ran it that way everything looked messed up

[ONE-CAM-EF]

i didnt go by that diagram up top because a few ppl said to match the colors and most of them did match but there was 2 white wires and u had to look for the bigger 1....well i ran those white wires both ways they can be....1 way wont start....and the other way will start but no gauges again...so somehwere in the same colored wires somethings wrong...and im not even sure if that diagram applies to me because when i ran it that way everything looked messed up

i think NHswap13203 can help you with that my friend..he did a jumper harness for me and it works great..so i think he could help you out with your dizzy problem...

[artymillz]

im PM him see what he says...thanks

[artymillz]

idk if this will help ne1 but heres my own diagram i made to show u how i have it wired

[artymillz]

would the distributor effect the rpm and speedometer gauges ? cuz they dont work at all.....i just updated this....my sdpeedo works just no rpms

[DOHCtor Miguel]

would the distributor effect the rpm and speedometer gauges ? cuz they dont work at all.....i just updated this....my sdpeedo works just no rpms

Yeah, the dizzy is what gives the tach signal.

You need to find a wire diagram from both harness' your using and then wire it, color matching might not work.