no power to amp

[single slam 12]

Do you have a cheap test light ?

[VtecVentry]

Just read it again, u said the when u jumper the remote side to a 12v power source it turns on fine?

[VtecVentry]

Iv seen the remote signal on decks go bad.. Most decks come with more than 1 acc power wire, if u have a decent deck there should be 1 wire for remote and 1 wire for power antenna. U can use the power antenna wire see if it turns back on.. good luck.. If it dosnt come on from that and it comes on if u jumper it, the deck acc power source is shot. I used to install stereos for Boomer McCloud awhile back

[blanco~db7]

Yea i used a test light just found 1 in my garage today.the remote wire is shot.i just spliced the remote from the amp to the red power wire

[DB-Audio]

yeah do that and run a switch on the remote wire so that way you wont kill your battery that would be my 2cents

[blanco~db7]

yeah do that and run a switch on the remote wire so that way you wont kill your battery that would be my 2cents

It actually turns on & off connected to the red.i had wired it to the yellow but it was on even when the car was off

[DB-Audio]

maybe your harness is a little different try wiring it to the blue wire usually thats the remote

[VtecVentry]

it will, yellow is memory, red is key'd opperated power orange (if u have it) is for the dimmer.. most dont have it anymore. Is there another blue wire on the back of the unit?

[VtecVentry]

If there is, use that instead, so when u turn ur radio off it turns off the amp or amps aswell

[blanco~db7]

Yea theres the blue/white (remote) plain blue (antenna?) But to the solid blue it turned the amp on but nth came out the subs

[blanco~db7]

I have it hooked tl the red & it turns the amp on&off with the radio so i think im good i hope lol

[DB-Audio]

atatch it to the blue/ white remote that should fix your problem but if your happy the way it works you should be ok

[blanco~db7]

atatch it to the blue/ white remote that should fix your problem but if your happy the way it works you should be ok

When its hooked up to the blue/white the amp doesnt turn on unless k run a wire from remote to 12v on the amp

[DB-Audio]

do you get any out put the way you have it now cause i know you said it turns on and off

[VtecVentry]

Run the remote wire bro.. thats the 1 that should be ran man, u'll sleep better at nite doing it right