no power to amp

[blanco~db7]

Had a single 10 with matching amp in my car. Was working fine till the other day it just stopped. I got back in my car a few mins later turned it on & it worked for a lil bit then stopped again. Thought it was the amp so I picked up new subs & amp. Everything is connected the correct way but the lights on neither amp turn on. Any suggestions or ideas why the amp isn't turning on
I've had numerous amp & sub combos in this car & never had an issue till now

[evo-mentalites-cc]

ur power wire connector to the fuse is prolly loose

[blanco~db7]

Thought that too. But I took it out & redid the power wire

[egkid129]

There's only 3 power connections to an amp, 12v, remote n ground check all 3 make sure there's voltage goin threw and a good ground...

[blanco~db7]

My boy just told me that the remote wire might be bad is there anyway to check with out a voltage meter

[88sprayinhatch]

make sure you have all connections are proper.. grounds usually act up. just take your time and redo all the wires.... if its a remote wire problem quick test is to just take a small strand of wire and jump the 12v to the remote turn on if it does not work check your ground . make sure you have voltage from the positive i seen people try to do this and never had power from the batt. if you have any questions just ask.

[thafenomeno19]

Ive got the perfect solution to all of those problems..... Dont install them in the 1st place stock speakers are good? Y waste the trunk space and battery life -__-

But good luck figuring it out

[blanco~db7]

Ive got the perfect solution to all of those problems..... Dont install them in the 1st place stock speakers are good? Y waste the trunk space and battery life -__-

But good luck figuring it out

Personal preference & I still have plenty of space.
thanks tho

[blanco~db7]

Bump

[blanco~db7]

make sure you have all connections are proper.. grounds usually act up. just take your time and redo all the wires.... if its a remote wire problem quick test is to just take a small strand of wire and jump the 12v to the remote turn on if it does not work check your ground . make sure you have voltage from the positive i seen people try to do this and never had power from the batt. if you have any questions just ask.

I ran a wire from 12v to remote & the blue power light came on but the subs don't do anything

[blanco~db7]

Any ideas my brother in law is possibly bringin me new wires but not sure

[blanco~db7]

With a wire running from remote to 12v it works fine

[blanco~db7]

Ttt

[blanco~db7]

New wires didnt help

[VtecVentry]

If new audio cables didnt work the pre-amp or the rca preouts shit the bed, havnt seen it in the past but i had a poineer last yr do the same thing to me.. i swapped out decks and everything came back to life. Took the deck back to best buy the next day.. I guess this new stuff they make these days is junk now